QC Lubricants
CAGE CODE 9Y364
 7360 Milnor St • Philadelphia, PA 19136
(215) 333-2000 Direct Line

Toll Free With Extension: (800) 887-2436
For Sales Manager: Dial Extension 203 for Stan Jakubowski
For Sales Assistance: Dial Extension 211 for Lu Ann Quinn


We actively supply a comprehensive line of MIL-SPEC  and commercial lubricants.

 

MIL-SPECS
Products
Chemical.net
MSDS
Product Shelf Life Data
PDS and other Docs Boeing Specs McDonnell Douglas Specs

ExxonMobile
Castrol
Shell
Valvoline
Anderol
LHB Industries

 

 
Aeroshelll

Alvania RL 3

Shell Gadus S2 V100 3


Formerly known as Alvania RL3



Product Description:

Gadus Greases are smooth-textured, amber colored lithium soap-thickened greases. These greases are also inhibited with additives that assure long service life and provide excellent lubrication and corrosion protection. Gadus Greases are excellent as general plant and electric motor bearing lubricants. Alvania Greases RL 1 and 2 are readily pumpable in pressure grease dispensing systems. Recognizing the trend toward the use of low-noise greases in general plant and electric motor bearing applications, Alvania Greases RL are formulated with non-crystalline additives to eliminate the hard particles that can lead to noise. The greases are tested to meet low-noise bearing requirements.

Applications:
• small and large bearings used in electric motors in consumer applications where low noise properties are desired
• factory-fill where the bearing manufacturer requires a low noise grease
 
Proper grease selection depends upon many factors, including bearing size, speed, temperature, load and method of application (hand gun, centralized systems). The bearing lubrication guide shown below will assist in this selection.

Antifriction Bearing Lubrication Guide
Alvania Grease RL 3
Alvania Grease RL 3 Operating Temperature, °F

Bearing Speed Factor *
0 to 150 150,000 to 300,000
100 to 275 75,000 to 150,000
100 to 275 150,000 to 300,000

*The bearing speed factor is the bearing bore measured in millimeters multiplied by the bearing shaft speed measured in revolutions per minute. For the purpose of converting millimeters to inches, one inch equals 25.4 millimeters.

Features/Benfefits:
• excellent lubrication
• excellent corrosion protection
• long service life

Typical Properties of Shell Gadus S2 V100 3

Gadus S2 V100 3

Test Method

 
Gadus S2 V100 3 Color

Visual

 Amber
Gadus S2 V100 3 Base Oil Viscosity: @40 °C, cSt

D 445

 98
Gadus S2 V100 3 Base Oil Viscosity: @100 °C, cSt

D 445

 9.4
Gadus S2 V100 3 Penetration, dmm Worked, 60X

D 217

 240
Gadus S2 V100 3 Penetration, dmm Worked, 10,000X, % Change

D 217

 8
Gadus S2 V100 3 Dropping Point, °F Mettler 385
Gadus S2 V100 3 Rust Prevention D 1743 Pass
Gadus S2 V100 3 Bomb Oxidation Pressure Drop @100 hrs, psi D942 5

Shell Alvania GreaseAeroshell